Configure universal control ISEL 48T-S48: Codes + instruction manual

Configure universal control ISEL 48T-S48

Learn how to configure your ISEL 48T-S48 control easily and quickly . Get your codes and setup instructions manual.

How to program the universal control ISEL 48T-S48?

Below you can see the steps to configure your ISEL 48T-S48 control by entering your code manually.

  1. Hold down the option of the device you need to program. Example: TV, audio, DVD, etc.

  2. now press the 4 digits of the code that corresponds to the device you need to configure. Find the code in the list available for download below.

  3. If the entered code is correct, the led light will turn on and off. 3 times signaling that the code has been configured successfully.

  4. And ready! the 48T-S48 control is ready to use, check that it works by pressing the start button POWER to turn on the device.

How to configure ISEL 48T-S48 control automatically?

Below you can find the configuration steps for the ISEL 48T-S48 control automatically by search.

  1. Garment manually the equipment without using the control 48T-S48

  2. press the option PROG during 3 seconds. The control light will stay on.

  3. now press the code 0000 (pointing at the TV or device).

  4. Keep pointing the 48T-S48 controller at your computer and repeatedly press the power button «POWER» until your computer turns off.

     Note: if you want to go back in the search, press the channel button down ▼ or up ▲ in case you want to go up.

  5. Finally, when the equipment is turned off, you must save the programmed code by pressing the «okay«. the led light will turn off and on 3 times signaling that the code has been saved successfully.

  6. And ready! Your 48T-S48 remote will have been programmed.

Manual ISEL 48T-S48

It may interest you:


How can I change the code of my 48T-S48 control for another device?

To enter a new code into your isel 48T-S48 remote, first remove the batteries and re-insert them to reset it.