Program Philips SRP2018/10 universal remote: Code list + Manual

Configure Philips SRP2018/10 universal remote

In this guide we show you how to program your Philips SRP2018/10 remote control easily and quickly. Get your codes and your programming instruction manual.

Configure Philips SRP2018/10 remote by code.

Below you can find the configuration steps to enter the corresponding code in the Philips SRP2018/10 remote.

  1. Turn on your TV without using the remote.

  2. Press and hold the button on the device (Example; TV) for 5 seconds until the red LED stays on.

  3. Find the device code in the list provided at the end of this guide.

  4. Enter the code corresponding to the device brand.

    ⚠ If the light turns off, the valid code will have been saved. Otherwise, the light will flash six times and then stay on to re-enter the code.

  5. And ready! Your controller is now configured.

Configure Philips SRP2018/10 remote automatically without code.

Below you can find the automatic configuration steps for the Philips SRP2018/10 remote.

  1. Turn on your TV without using the remote.

  2. Press and hold the button on the device (Example; TV) for 5 seconds until the red LED stays on.

  3. Next, point the Philips SRP2018/10 remote at your device and press the power button multiple times (1 at a time) to begin tracking the code.

  4. When the device turns off, please press the “OK” button immediately to save the code. The LED indicator will turn off.

  5. And ready! Your control is now configured and ready to be used.

Philips SRP2018/10 universal remote control manual and code list

It may interest you:

FAQs:

¿How to restart my control to program it again?

To reset the controller, simply remove the batteries and reinsert them after 30 seconds.