How to program Philips SRP3004/53 universal remote control: Code list + Manual

Configure universal remote control Philips SRP3004/53

Through these instructions we teach you how to configure and program your Philips SRP3004/53 remote control easily and quickly. Download your list of codes and your programming instruction manual.

Configure Philips SRP3004/53 remote by code

Below you can see the programming instructions for your Philips SRP3004/53 remote by entering the corresponding code for each device.

  1. Turn on the TV manually or use the original remote control. Tune to channel 1.

  2. Press and hold the “TV button” or the corresponding device for 5 seconds until it flashes twice and stays on.

  3. Find the code corresponding to your brand of television in the list provided at the end of this guide.

  4. Enter the corresponding code with the numbers of the control.

  5. The button will flash twice and stay on. If the button flashes once for a long time, the code has not been entered correctly or the wrong code has been entered and you will need to enter a new code.

  6. Next, point the remote at the TV or device and press and hold the “POWER” button until the TV or device turns off.

  7. Turn on the TV and check that the buttons work properly.

    ⚠ Press the TV button twice to exit setup mode and save your settings. When no button is pressed for 2 minutes, the remote will automatically exit setting mode.

  8. And ready!

Philips SRP3004/53 universal remote control manual and code list

It may interest you:


¿The entered code does not work, what can I do?

If the remote code does not work, repeat the setup steps and try again by entering the next code on the list.