Configure Philips SRP5004/86 universal remote: Code list + Manual

In this guide we show you how to configure your Philips SRP5004/86 remote control easily and quickly. Get your codes and setup instructions manual.

¿How to configure the Philips SRP5004/86 remote control by code?

Below you will find the instructions to configure your Philips SRP5004/86 remote by entering the corresponding device code.

1. Turn on your TV without using the remote and tune to channel 1

2. Press and hold the button on the device to be configured for 5 seconds until the red configuration LED indicator lights up.

   

   The remote will enter setup mode

3. Find the code corresponding to the brand and device in the list located at the end of this guide.

4. Enter the code corresponding to your device.

   ⚠ If the red LED indicator turns off, an invalid or wrong code has been entered. In that case, please try again.

   

5. Point the remote control at the TV and press and hold the “Power” button until the TV turns off.

   

   💬This step normally lasts between 5 and 60 seconds. In some extreme cases, this step can take up to 15 minutes.

6. Turn on the TV and check that all the buttons work properly and voila!

FAQs: