How to program and configure universal control RCA RCR612 with and without codes + instruction manual

We show you how to configure and program the RCA RCR612 universal control for TV, DVD, Smart TV and all the devices available for each model. Get their setup codes and instruction manuals.

How to program RCA RCR612 universal remote automatically without codes

Below we show you the configuration steps for the RCA RCR612 control automatically and by tracking the device code.

1. Manually turn on the TV or device you want to control.

2. On the RCR612 control, keep the button of the corresponding device pressed, eg: TV, and at the same time press the ON/OFF key until the red light turns on.

3. Next, point your RCA universal remote at the television or device and press the PLAY ▶ option.

4. Wait for the TV to turn off. (if nothing happens and the red light stays on, after 3 or 4 seconds, press the PLAY ▶ option again).

5. Once your TV turns off, the next step is to press the REVERSE (REW) option and wait a few seconds for the TV to turn on. If after 3 or 4 seconds it does not turn on, press the REVERSE option again.

   ⚠This must be done until the TV or device turns on.

6. When the TV turns on, press the STOP button to stop searching and save the settings.

7. And ready! The RCR612 control will be programmed.