Programming universal control STEREN RM-1600: List of codes + Manual

In this guide we show you how to configure your Steren RM-1600 universal control. We show you its list of codes for televisions and its manual to download.

Steren RM-1600 auto code setup.

Below we show you the steps to configure your RM-1600 control automatically.

1. Turn on your TV without using the remote.

2. point to your tv and keep pressing the SET button until you see the volume on your TV screen.

   

3. As soon as you see the volume on your TV, immediately release the buttonSET.

   Important: the code scanning time may vary depending on the TV model between 10 seconds to 5 minutes or more.

4. And ready! your control is ready to be used, check that all the buttons work or if not, repeat the configuration process again.

Programming RM-1600 by brand of popular TVs.

1. Turn on your TV without using the remote.

2. point to your tv and press and hold the button that indicates the brand of the television (until the volume increases).

   

3. Immediately release the button when you see the volume on screen.

4. And ready! your control is programmed and configured for use.

Configure RM-1600 control by code list.

1. Turn on your TV without using the RM-1600 control.

2. point to the tv and hold down the SET button and at the same time the power button for 6 to 10 seconds until the led indicator stays on.

   

3. When the led is on, look for the code corresponding to the television in the manual that you will find at the end of this guide.

4. Enter the code on the TV and wait for the control’s LED light to flash 2 times.

5. To finish, press the power button, if your TV turns off, it has been configured correctly, otherwise re-enter another code from the list.

FAQs: