Configure Philips SRP2002/10 universal remote: Code list + Manual

In this guide we show you how to program your Philips SRP2002/10 remote control easily and quickly. Get your codes and setup instructions manual.

Configure Philips SRP2002/10 remote by entering the corresponding code.

Follow the steps below to enter the code corresponding to your device in the SRP2002/10 controller.

1. Turn on your TV or device.

2. Press and hold the button corresponding to the device (On: TV or DVD) for 5 seconds until the LED indicator lights up.

3. Find the code corresponding to your device in the list at the end of this guide.

   

4. Enter the code of your device.

   ⚠ If the green setup indicator turns off, an invalid or wrong code has been entered. In that case, please try again.

   

5. Next, point the remote at the TV or device and press and hold the “Power” button and release it immediately as the TV turns off.

   This step lasts between 5 and 60 seconds. In some extreme cases, this step can take up to 15 minutes.

6. Check that the remote works correctly.

7. To finish press the device button “twice” to save the code and exit configuration mode.

   

8. And ready!

FAQs: