Configure Philips SRP2008B/86 universal remote control: Code list + Manual

Configure universal remote control Philips SRP2008B/86

Discover how to program and configure your Philips SRP2008B/86 remote control easily and quickly. Know your codes and programming instructions manual.

¿How to configure the Philips SRP2008B/86 remote control by code?

Below you can see the instructions to program and configure your Philips SRP2008B/86 remote by placing the corresponding code.

  1. Turn on your TV and tune to channel 1

  2. Press and hold the corresponding device button for 5 seconds until the red setup LED lights up.

    💬 The remote will enter setup mode

  3. Locate the code of the brand and device in the list that you will find at the end of this guide.

  4. Enter the code corresponding to your team.

    ⚠ If the LED indicator turns off, it means that an invalid or wrong code has been entered. In that case, please try again.

  5. Point the SRP2008B/86 remote at the TV and hold down the “Power” button until the TV turns off.

    💬This step normally lasts between 5 and 60 seconds. In some extreme cases, this step can take up to 15 minutes.

  6. To finish, turn on the TV and check that all the keys work correctly and voila!

Philips SRP2008B/86 remote control code list and manual

It may interest you:


¿What batteries does the controller use?

The controller uses 2 AAA type batteries.