How to program Philips SRP5016/10 universal remote: Codes + Manual

Learn how to configure your Philips SRP5016/10 remote control easily and quickly. Get your code list and your configuration instruction manual.

How to program Philips SRP5016/10 universal remote by code?

Below you will find the configuration instructions for the Philips SRP5016/10 remote by entering the code for each device.

1. Turn on the TV or device.

2. Press and hold the button corresponding to the device (eg TV) for 5 seconds until the red LED turns on.

   

3. Find the 5-digit code for your device brand in the list of codes at the end of this guide. The codes are listed by device type and brand. The most recommended code appears first.

4. Enter the first 5-digit code using the number buttons.

   ⚠ If a code is valid it will be saved and the light will remain off. Otherwise, the light will blink once and stay on to re-enter the code.

   

5. And ¡ready!

¿How to program the Philips SRP5016/10 universal remote automatically?

Follow the steps below to program your Philips SRP5016/10 universal remote automatically.

1. Turn on the TV or device.

2. Press and hold the button corresponding to the device (eg TV) for 5 seconds until the red LED turns on.

   

3. Point the universal remote at the tv or device, and then press and release the “POWER” button repeatedly to scan the device code.

   

4. When the device turns off, immediately press the “OK” button to save the code. The red LED indicator will turn off.

   

5. And ¡ready! Finally, use the universal remote to control the configured device.

   ⚠ If the device responds correctly, it means that you have saved the correct code.

FAQs: